Symbol P460 Product Reference Manual page 63

Problem
Scanned data is
incorrectly displayed on
the host.
The scanner emits
error beeps after
decoding a bar code.
Received a
communication error
beep while using a
Synapse cable.
Table 4-1. Troubleshooting Table (Continued)
Possible Causes
Scanner is not
programmed to work
with the host.
Cradle is not powered
up or cable
connections are not
secure.
Scanner is too far from
the base for proper
transmission.
Previously scanned
data not transmitted to
host.
The cables connected
to the cradle were not
connected in the
correct sequence.
Maintenance And Specifications
Possible Solutions
Ensure the proper host type is selected.
Check the scanner host type parameters or
editing options:
• For RS-232, ensure the scanner's
communication parameters match the
host's settings.
Check that the cradle is powered up and that its
cable connections are secure. See Setting Up the
Cradle on page 2-4.
Move closer to the base and retransmit.
Ensure you are within the proper RF transmission
range.
Before power is applied to the cradle, the
Synapse cable must be connected to the cradle
AND the flying power lead plugged in. See Using
A Synapse Cable with the cradle on page 2-9 for
more information
4-3