4Warm.up - TOHATSU 50 Owner's Manual

Hide thumbs Also See for 50:
Table of Contents

Advertisement

(5) Wind the starter rope around the flywheel a few turns. Give it a sharp tug
to start the engine. Use a socket wrench or similar to get a firm grip on
the end of the rope.
A
CAUTION
Be careful that your clothes
or other items do not get caught in the
rope or other engine parts.
To prevent
your clothes
and other items to get caught in the engine,
do not reinstall the flywheel
cover nor the Upper Engine Cover after
the engine is started with the stalter
rope. In this case be sure nobody
sits in the vicinity of the engine, and run carefully.
Immediately
contact
an authorized
TOHATSU
dealer when
reaching
shore.
4 Warm-up
Before driving the boat, let the engine run at low speed for approximately
three minute to let it warm
and allow the oil to circulate through the
machine. If the engine is not warmed up beforehand. the engine life will
shorten greatly. During the warm-up operation. confirm that cooling water is
discharged from the check port and idle port.
48

Advertisement

Table of Contents
loading

Table of Contents