Other Programming - Panasonic KX-TGL460 Operating Instructions Manual

Programming
6
Enter the desired number. a MOKN
a MSELECTN
R "Baby monitor" will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to "On".
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "Off" a MSELECTN a MOFFN
Editing an outside monitoring number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line.
5
MMENUN a MbN: "Edit" a MSELECTN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a
MOKN a MSELECTN
Erasing an outside monitoring
number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line.
5
MMENUN a MbN: "Erase" a MSELECTN
6
MbN: "Yes" a MSELECTN a MOFFN
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
For assistance, please visit http://shop.panasonic.com/support
42
TGL46x(en)_1007_ver003.pdf
1
2
3
Answering the baby monitor
n When monitoring with a handset:
n When monitoring from outside:

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 43).
1
42
Press MMENUN on the handset being
monitored.
MbN: "Sensitivity level" a
MSELECTN
MbN: Select the desired setting. a
MSAVEN a MOFFN
Press M /ZN to answer a call.
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to "On" (page 25).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds.
To answer the call, press MOFFN, then
press M /ZN.
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.
MMENUN#104
2015/10/07 14:36:39