General Operation - Axxera AXM140BT Owner's Manual

Power On/Off
Mode
Display
Reset
Set the Clock
Auxiliary Input
Volume
Preset EQ Curves
AXM140BT
Press or any other button to turn the unit on. Press
again to turn the unit off.
Press MODE to select between AM/FM, USB,
Bluetooth or auxiliary input modes. Modes of operation
are indicated in the display. USB mode will not appear
unless a USB device is connected.
The radio frequency (tuner mode) or MP3 title/track
information (USB mode) will be shown by default. Press
DISP to display the clock. The default display will return
after five seconds.
When in USB mode, the display will alternate between
track number/elapsed time and available MP3
information, including file name, song title, artist name,
album name and folder name.
Press RESET upon initial installation or if abnormal
operation occurs. Reset button is located in the top
right corner.
Press DISP to display the clock, then press and hold
DISP until the hours will flash. Rotate the volume knob
to adjust the hours. Press the volume knob, and the
minutes will flash. Rotate the volume knob to adjust the
minutes.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc.
Adjust volume using the volume knob (00-40).
Press EQ to select between the following preset
equalization curves: FLAT, POP, JAZZ, ROCK and OFF.
Note: Ability to manually adjust Bass and Treble settings
is disabled when a preset equalization curve is selected.
Setting equalization curves to OFF enables manual Bass
and Treble adjustments.
OPERATION

General Operation

5