Service Information; Specifications; Maintenance; Protecting The Environment - Black & Decker CS1030L Instruction Manual

7-1/4” (184mm) circular saw

Hide thumbs Also See for CS1030L:

Instruction manual (13 pages)

Instruction manual (26 pages)

Table Of Contents

Table of Contents

Available languages

ENGLISH

Where splintering is to be minimized, e.g. when cutting

laminates, clamp a piece of plywood onto the top of the

workpiece.

Pocket cutting (Fig.14)

Pocket cutting is used to cut a hole in a piece of material

without cutting from the side.

Measure and mark work.

Tilt saw forward and rest front of the shoe on material to

be cut. Align so that cut will begin at the back of the drawn

rectangle shown in Fig. 14.

Using the retracting lever, retract blade guard to an

upward position, with the blade just clearing the material,

start motor and gradually lower the saw into the material.

Warning! As blade starts cutting the material, release the

retracting lever immediately.

Never tie the blade guard in a raised position.

When the shoe rests flat on the material being cut,

complete the cut in forward direction.

Allow the blade to come to a complete stop before lifting

saw from material.

When starting each new cut, repeat the above steps.

Wrench storage (Fig.15)

The blade wrench (9) can be stored on the saw shoe as

shown in Fig. 15.

MAINTENANCE

Your tool has been designed to operate over a long period of

time with a minimum of maintenance. Continuous satisfactory

operation depends upon proper tool care and regular cleaning.

Warning! Before performing any maintenance, switch off

and unplug the tool.

Regularly clean the ventilation slots in your tool using a

soft brush or dry cloth.

Regularly clean the motor housing using a damp cloth.

Do not use any abrasive or solvent-based cleaner.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be

disposed of with normal household waste. Should

you find one day that your Black & Decker product

needs replacement, or if it is of no further use to you,

do not dispose of it with household waste. Make this

product available for separate collection.

Separate collection of used products and packaging

allows materials to be recycled and used again.

Re-use of recycled materials helps prevent

environmental pollution and reduces the demand for

raw materials. Local regulations may provide for

separate collection of electrical products from the

household, at municipal waste sites or by the retailer

when you purchase a new product.