2.2
Wiring Optional Equipment
Navigator
Use cable type MJ-A6SPF0011/0012 (option) to connect the navigator to the NMEA connector
on the standard LCD monitor unit or Interface Unit in case of blackbox system. For detailed
information see the interconnection diagram at the back of this manual.
Water temperature sensor T42, T80
Connect the water temperature sensor cable to the TEMP connector on the processor unit.
Net Sonde FNZ-18
Use connector type FM14-8P (option) and five-pair cable CO-SPEVV-SB-C 0.2X5P (or
equivalent, local supply) to connect the Net Sonde to the SONDE connector on the processor
unit. Attach the connector to the cable as below.
Analog sonde signal and sonde temperature may also be input. For details see the
interconnection diagram at the back of this manual.
Figure 2-11 Fabrication of cable for net sonde
2-8