Disposal; Manufacturer's Warranty - Tools - Hilti DX 76 Original Operating Instructions

Fault
The piston can't be fitted.
The piston guide can't be fitted.
Stiff cycling action.

10 Disposal

Most of the materials from which Hilti tools or appliances are manufactured can be recycled. The materials must
be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back old tools and appliances for recycling. Ask Hilti customer service or your Hilti representative for further
information. If you bring the tool to a recycling facility yourself, follow the applicable regional and international directives
and regulations.

11 Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
components and spare parts, or other products of equiv-
alent quality, may be used in the tool.
This warranty provides the free-of-charge repair or re-
placement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a
result of normal wear and tear are not covered by this
warranty.
Printed: 17.04.2014 | Doc-Nr: PUB / 5126191 / 000 / 02
Possible cause
The tip of the pusher is projecting into
the piston guide, preventing move-
ment of the piston.
The lever is in the closed position.
The piston guide is incorrectly posi-
tioned.
The tool needs to be cleaned.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular, Hilti
is not obligated for direct, indirect, incidental or con-
sequential damages, losses or expenses in connec-
tion with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send the tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
Remedy
Pull the pusher forward until it en-
gages.
Open the lever.
Insert the piston guide in the correct
position.
Clean the tool.
See section: 8.2.2 Cleaning the piston
guide 18 19 20 21
en
15