Introduction; Connections - Prodipe CAB100 User Manual

1 – Introduction
Thank you for choosing this PRODIPE product.
Safety Information
To ensure both your safety and the proper functioning of this product, please take
the time to read the safety instructions on the back cover.
WARNING. To avoid any possibility of electric shock, please do not remove the
back panel of this product. For any repair work please contact either the shop
where you purchased the product or a qualified technician.
Please note that when the volume is turned up high, this equipment can produce
sound levels which may irreparably damage your hearing.
2 – Connections
To ensure that your speaker is properly connected, please adhere to the following steps:
1. Check your audio lead.
2. Switch on the equipment you intend to use with the speaker (console, PC, audio
equipment, etc.).
3. Check the speaker settings and your audio equipment (volume turned down to its
lowest level).
4. Check the voltage , turn the speaker POWER switch  to ON - the red LED  should
light up.
Note that: when powering off, the Prodipe speaker should be switched off first (switch  to
OFF and red LED  goes out).
Important: the choice of voltage via the AC SELECT switch  depends on your power
supply. Any change to the voltage should be carried out when the speaker is off (switch  to
OFF and speaker unplugged from the power supply). When setting up your speaker, please
pay regard to the following procedure:
POWER SUPPLY
AC SELECT
FUSE
Actual product(s) may differ from illustrations/photographs used
CAB 100
100V – 120V 220V – 240V 100V – 120V 220V – 240V

115V

T2AL
Figure 1
Copyright © 2012 IPE Music
CAB 200
230V 115V
T1AL T3, 15AL
230V
T1, 6AL
-1-