Setting The Chainsaw Tension; Oil Filling - Eckman EKECS03 Instruction Manual

Setting the chainsaw tension

Tensioning chain for model with SDS tool-less tensioning system
Loosen the lock knob by turning it anti-clockwise approximately 1-2 turns.
Check whether all chain links lie correctly in the guide tracks of the bar.
Press the tension ring inwards and turn it in a clockwise direction until the correct chain tension
is reached
.
The correct tension is reached when the chain in the middle of the bar can only be raised by
approximately 3-4mm. Please see figure

Oil filling

Note. The chainsaw is shipped without oil in it. The chain saw must never be used without oil or
with an oil level that is below the indicator. SAE #0W-30 is ideally recommended for general
use.
Oil level
window
WARNING. Always ensure that the chainsaw is switched off and the plug is removed from the
power point before making any adjustments.
1.Remove oil cap and fill the tank with chain oil. Replace the oil tank cap and tighten well.
2.Lubrication is activated only when the machine is working.
3.Check the oil level periodically through the oil level indicator.
Use good quality ecological chain oil to ensure long life for the moving parts. Do not use
recovered or pre-used oil containing impurities.
Make sure that no dirt gets into the oil tank.
as below.
- 8 -