Chainsaw Maintenance - Eckman EKECS03 Instruction Manual

- 14 -

Chainsaw maintenance

WARNING. Always ensure that the machine is switched off and the plug is removed from the
power point before making any adjustments or maintenance procedures.
1. Always keep the air holes clean on the electric chainsaw body. They tend to become clogged
with sawdust during use and this affects the efficiency of cooling, causing overheating of the
motor. Electric motors that become damaged due to being clogged up with debris are
not covered by this warranty.
2. Do not operate the chainsaw with the air intake on the ground as this will draw foreign
particles into the motor area and damage the windings of the motor.
3. Regularly check to see if any dust or foreign matter has entered the grills near the motor and
around the on/off switch. Use a soft brush and/or vacuum to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
4. If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be
used. Do not use alcohol, petrol or other cleaning agents or abrasives.
5. Never use caustic agents to clean plastic parts.
6. Turn the bar periodically to use both the sides so that it wears evenly.
7. It is essential that motor cooling vents are kept free from a build-up of sawdust and this
decreases the engines tools cooling capacity and causes overheating equipment, oil pump etc.
It is recommended that this is carried out after every use.
8. Clean the guide and oil holes periodically.
9. De-burr the race sides periodically with a flat file. Time may cause any "burrs" to detach and
damage the bar.
10. The bar needs to be evened with a flat file if one of the races is higher than another and then
smoothed with a file and fine sandpaper. If races are considerably worn, check that the height