Setting Chain And Chain Bar - Eckman EKECS03 Instruction Manual

Setting chain and chain bar

Chain and chain bar assembly for model with SDS tool-less tensioning system
Place the chainsaw with the motor on a cover to avoid any mess from
the oil.
Place the chain in the grove of the bar. Pay attention to the correct
running direction. As shown by the running direction symbol.
Place the chain links around the drive sprocket and let the fastening bolt pass through
1.
gap of bar. ( See Fig. 1-2)
Fig.2 Drive sprocket
Fig.1
2. Check if all parts are seated properly and hold chain and chain bar in a level position.
Fit cover and match the tension ring properly, then tighten the lock knob clockwise.
(See Fig.3)
Drive sprocket
Fastening bolt
Fastening bolt
Fig.3
Fig.2
Tension ring
Lock knob
- 7 -
the