Table of Contents
Advertisement
Setting chain and chain bar
Chain and chain bar assembly for model with SDS tool-less tensioning system
1.
Place the chainsaw with the motor on a cover to avoid any mess from the oil.
2.
Place the chain in the grove of the bar. Pay attention to the correct running direction. As shown by the running
direction symbol.
3.
Place the chain links around the drive sprocket and let the fastening bolt pass through the hole of chain clamp.
If necessary, adjust chain clamp to tension chain a little.
4.
Check if all parts are seated properly and hold chain and chain bar in a level position.
5.
Fit cover and match the tension ring with the chain clamp. And then tighten the lock knob clockwise and screw
with screwdriver.
Please see Figures:
1.
drive sprocket
2.
chain clamp
3.
fastening bolt
4.
tension ring
5.
lock knob
6.
screw
Setting the chainsaw tension
Tensioning chain for model with SDS tool-less tensioning system
1.
Loosen the lock knob by turning it anti-clockwise approximately 1-2 turns.
2.
Check whether all chain links lie correctly in the guide tracks of the bar.
3.
Press the tension ring inwards and turn it in a clockwise direction until the correct chain tension is reached.
4.
The correct tension is reached when the chain in the middle of the bar can only be raised by approximately
3-4mm. Please see the right figure
Oil filling
Note. The chainsaw is shipped without oil in it. The chain saw must never be used without oil or with an oil level that
is below the indicator.
WARNING. Always ensure that the chainsaw is switched off and the plug is removed from the power point before
making any adjustments.
1.
Remove oil tank cap and fill the tank with chain oil. Replace the oil tank cap and tighten well.
2.
Lubrication is activated only when the machine is working.
3.
Check the oil level periodically through the oil level indicator.
4.
Use good quality ecological chain oil to ensure long life for the moving parts. Do not use recovered or pre-used
oil containing impurities.
5.
Make sure that no dirt gets into the oil tank.
Checking the automatic oil function
Check the automatic operation of the chain lubrication by pointing the tip of the switched-on saw towards a piece of
paper laying on the ground. If a patch of oil appears and becomes larger, then the automatic oil function is working.
If there are no traces of oil even though the oil tank is full, then the automatic oil function is not working.
If the automatic oil function is not working, remove the chain bar and clean out the oil ways of the chainsaw and
- 5 -
Hide quick links:
Advertisement
Table of Contents
