Table of Contents
Advertisement
Checking the automatic oil function
Switch on the chainsaw, rev it up and point the tip
the ground. If a patch of oil appears and becomes larger, then the automatic oil function is
working. If there are no traces of oil even though the oil tank is full, then the automatic oil
function is not working.
If the automatic oil function is not working, remove the chain bar and clean out the oil ways of
the chainsaw and chain bar. After reassembly, if the chainsaw is still not working, please take
it to an authorized service centre.
Avoiding kickback
Be constantly aware of the position of the upper quadrant of the blade tip. This is the part that
triggers a kickback when it hits resistance.
Never engage the upper quadrant of the guide bar with whatever you are cutting. Look out for
hidden branches or obstructions. Ensure there is a clear work area.
Always clear away brush, vegetation and any obstructing debris before attempting a cut that
might trigger a kickback.
Avoid cuts that will cause the chainsaw to jam in a tree trunk or limb.
Avoid jamming
Always cut into the compression wood first until the cut starts to close. Always make the
compression cut beneath of the log or limb is suspended from one end and on top if it is
supported at both ends. Cut from the other side towards the compression cut. Make a habit of
using a wedge to prevent the compression cut jamming tighten the chainsaw blade.
Power cord support
During use of the chainsaw the power cord will continually be pulled
as you move from one area to another.
A cord retention hook has been provided on the
chainsaw housing.
Before start-up
1. Check the machine and cable are in good working order before starting the chainsaw.
2. Make sure that the chain lubrication is working and check the oil level.
3. Check the chain tension and the operation of the chain brake.
Start up and stop
1. Remove the bar cover.
2. Release the chain brake by pulling the front hand guard, firmly towards the back of the
electric chain saw until a click is heard. To check the chain brake has been released, you
should be able to move the chain by hand.
3. Connect the cable to the power.
of the saw towards a piece of paper laying on
- 9 -
Advertisement
Table of Contents
