Canon lbp5970 Getting Started Manual page 46

1
Make sure that the Job indicator is off.
Cancel Job
Online
Feeder Selection
Ready
2
Press " " of the power switch on the printer.
When Using a Hard Disk (Only When a Hard Disk Is
Installed)
When using the optional hard disk, turn the printer OFF using the following
procedure.
IMPORTANT
•
If you perform a shutdown when any job of which you stopped the
operation or of secured print in the hard disk, the message <JOBS
REMAIN> is displayed. If you perform a shutdown, all the jobs are deleted.
However, the jobs stored in the boxes are saved in the hard disk as it is.
When you want to continue to print, press [Online] to place the printer
online.
•
Once you perform a shutdown, you cannot cancel the operation in
midstream. When you want to turn the printer ON again, turn the printer
OFF once following the instruction of the message, and then turn the
printer ON.
Downloaded from ManualsPrinter.com Manuals
Job
Power
Utility Settings
OK
Message HDD Job
Main Power
Reset
Off
NOTE
You can also perform SHUT DOWN in the RESET menu by pressing
[Reset] on the control panel. For more details, see "Chapter 5 Printing
Environment Settings" in User's Guide.
1
Make sure that the Job indicator and HDD
indicator are off.
Cancel Job
Online
Feeder Selection
Power
2
Hold down the control panel power switch (sub
power supply) on the control panel until <02
SHUTTING DOWN> is displayed, then release the
switch.
Hold down the switch (approximately 4 seconds) until <02
SHUTTING DOWN> is displayed. If the switch is released in less
than 4 seconds, and POWER SAVE MODE is set to a setting value
other than OFF, the printer enters Power Save Mode. (See User's
Guide)
02 SHUTTING DOWN
3
Confirm the message.
TURN OFF POWER
When the printer is ready to be turned OFF after the process for it is
performed, the message <TURN OFF POWER> appears.
Job
Power
Utility Settings
OK
Ready Message HDD Job
Main Power
Reset
Off
Step
7
45