Installing The Igate; Step 2. Remove Existing Thermostat; Step 3. Install The Igate - ClimateMaster iGate Connect Installation Manual

INSTALLING THE IGATE

THERMOSTAT
There are 5 steps to install the ClimateMaster iGate
thermostat:
Step 1. Power Off Trilogy® Unit
Step 2. Remove Any Existing Thermostat

Step 3. Install the iGate

Step 4. Connect the Wiring
Step 5. Power On Trilogy® Unit
Step 1. Power Off Trilogy
Before disconnecting the existing thermostat, or installing
™
the iGate Connect thermostat, disconnect the power to the
heating and air conditioning equipment.
Step 2. Remove Any Existing Thermostat
Disconnect the wires to the existing thermostat (if applicable)
and remove it from the wall (if you are installing the iGate
Connect thermostat in the same location).
Step 3. Install the iGate
Thermostat
The ideal location for the thermostat is approximately 5 ft (1.5
m) above fl oor level in the main living area.
Do not install the thermostat:
Close to sources of heat such as incandescent lights
Near supply heating/cooling sources
™
Connect Thermostat
®
Connect
™
™
CONNECT
™
Connect
Unit
™
9