Network Deployment - Vivotek MS8391-EV User Manual

VIVOTEK

Network Deployment

General Connection (PoE)
When using a PoE-enabled switch
The Network Camera is PoE-compliant, allowing transmission of power and data via a sin-
gle Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-
enabled switch via Ethernet cable.
Depending on the requirements of your installation site, select
an appropriate power source, such as an 802.3at PoE (30W)
for operating temperature higher than -10ºC. For extremely
low temperature, you will need a power source higher than
35W, such as 24V AC.
If using an 802.3at PoE as the power source, the lowest op-
erating temperature is -20ºC.
When using a non-PoE switch
Use a 802.3at PoE power injector (optional) to connect between the Network Camera and a
non-PoE switch.
NOTE:
1. The camera is only to be connected to PoE networks without routing to outside plants.
2. For PoE connection, use only UL listed I.T.E. with PoE output.
18 - User's Manual
PoE Power Injector
(optional)
7 5 3 1
ON
9 10
100~240V
LAN/PoE
AC
OFF
8 6 4 2 GE LAN GE LAN
802.3at
PoE Switch
Non-PoE Switch