ATTO Technology ExpressPCI FC 3321, FC 3322, FC 3342 Installation And Operation Manual page 19

5 If ExpressPCI FC does not appear in the
Device List, try reloading the driver software
as described in Chapter 4 of this manual.
6 If it is started, go back to the Devices tab of
the SCSI adapters utility window and double
click on the ATTO ExpressPCI host adapter
description, and then on the bus it is
assigned to. All of the external devices
connected in the loop should be identified.
If they do not appear in the Device List, the
external devices or connection are not
working properly.
❖If the card has been recently re-flashed with
new firmware, the new NT driver must be
installed.
❖For Intel-based PCs, check the computer
CMOS setup and verify that the PCI slots
are configured correctly. Procedures vary
greatly: refer to the manual supplied with
your system or call the computer supplier
for configuration assistance.
❖If these suggestions do not solve the
problem, re-flash the host adapter and re-
install the Windows NT driver.
14