Chrysler 2017 PACIFICA User Manual page 45

• Adjusting a seat while driving may be dangerous. Moving a seat while driving could result in
loss of control which could cause a collision and serious injury or death.
• Seats should be adjusted before fastening the seat belts and while the vehicle is parked.
Serious injury or death could result from a poorly adjusted seat belt.
• Do not ride with the seatback reclined so that the shoulder belt is no longer resting against
your chest. In a collision you could slide under the seat belt, which could result in serious
injury or death.
Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger seats may be equipped with power lumbar.
The power lumbar switch is located on the outboard side of the power seat. Push the switch
forward or rearward to increase or decrease the lumbar support. Push the switch upward or
downward to raise or lower the lumbar support.
Driver Memory Seat — If Equipped
The Memory Buttons 1 and 2 on the driver's door panel can be programmed to recall the driver's
seat, outside mirrors, and radio station preset settings. Your Remote Keyless Entry (RKE) Key
Fobs can also be programmed to recall the same positions when the UNLOCK button is pushed.
Your vehicle may have been delivered with two
RKE Key Fobs, one RKE Key Fob can be linked
to each of the memory positions.
Programming The Memory Feature
To create a new memory profile, perform the
following:
1. Cycle the vehicles ignition to the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., driver's seat, outside mir-
rors and radio station presets).
3. Push and release the S (Set) button on the memory switch.
4. Within five seconds, push and release either of the memory buttons (1) or (2). The Instrument
Cluster Display will show which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be in PARK to
recall a memory profile.
• To set a memory profile to your RKE Key Fob, refer to "Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory" in this section.
G E T T I N G S T A R T E D
WARNING!
Driver Memory Switch
43