DO NOT grab the door handle, when pushing the door handle button. This could unlock the
door(s).
Push The Door Handle Button To Lock
NOTE:
• After pushing the door handle button, you must wait two seconds before you can lock or
unlock the doors, using either Passive Entry door handle. This is done to allow you to check if
the vehicle is locked by pulling the door handle, without the vehicle reacting and unlocking.
• The Passive Entry system will not operate if the RKE Key Fob battery is dead.
The vehicle doors can also be locked by using the RKE Key Fob lock button, or the lock button
located on the vehicles interior door panel.
Lock Or Unlock The Power Liftgate
With a valid Passive Entry RKE Key Fob within 5 ft (1.5 m) of the liftgate, cycle the handle to open
the liftgate and pull the liftgate open with one fluid motion.
NOTE:
• All doors will remain locked when the liftgate release handle is pushed regardless of the driver's
door unlock preference setting ("Unlock Driver Door 1st Press" or "Unlock All Doors 1st Press").
• Refer to "Keyless Enter-N-Go — Passive Entry" in "Getting To Know Your Vehicle" in your
Owner's Manual on the DVD for further information.
G E T T I N G S T A R T E D
Do Not Grab The Door Handle When Locking
19