Icom IC-F5061 Servise Manual page 20

SECTION 3
1. Removing the front panel
q Turn the transceiver's power OFF, then disconnect the DC
power cable
w Unscrew the 4 bottom screws, then remove the bottom
cover from the transceiver in the direction of the arrow.
e Remove the front panel from the main body using a
standard cabinet screw driver as shown below.
r Disconnect the flat cable from the front panel.
Flat cable
Flat cable
Front panel
DISASSEMBLY INSTRUCTION
Bottom cover
Standard
screw driver
Main body
Front panel
Main body
Front panel
2. Removing the MAIN UNIT
q Unscrew 7 screws A, and unsolder 3 points B.
w Unscrew 3 screws C and remove the shield cover.
e Unsolder 3 points D (at the antenna connector) and
5 points E (at the PA module).
r Remove the clip.
t Remove the bush, and remove the MAIN UNIT in the
direction of the arrow.
3 - 1
A
B
C
Shield cover
D
E
Clip
Bush