Fujitsu SPARC Enterprise M3000 Product Notes page 70

XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O O
130801-002
RTIF1- O
140131-001
RTIF1- O O
140611-001
RTIF1- O O
141002-001
54 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
M8000
M9000 Description
O
While XSCF is running, "XSCF panic
detected" or "XSCF Watchdog
timeout" may be detected, and XSCF
may reset.
O In a configuration with even
numbered domains, if the following
operation is executed when half of the
domains have become inactive
("Degraded" state) due to failures or
configuration violations, either all the
running domains stop or the
restarting of such domains fails
[Operation]
1. Remove all XSBs of the domains
which have become inactive (by
executing the "deleteboard -c
unassign" command).
2. Execute poweron or reboot on any
of the domains which has not become
inactive.
O Security fixes. (CVE-2014-0224)
For detail, see the Oracle website
related to the following:
Critical Patch Updates
O Security fixes (see MOS Doc Id
1934739.1)
Workaround
M3000/M4000/M5000 servers:
Check that XSCF is started.
If not started, stop all the domains and
then execute a system power off/on (AC
OFF/ON).
To turn on the system power that you
turned off, wait at least 30 seconds before
power-on
M8000/M9000 servers:
Check that XSCF is started.
If there is an XSCF unit that has not
started, execute the replacefru(8)
command, and then uninstall the
XSCF unit and install it again. Or stop
all the domains and then execute a
system power off/on (AC OFF/ON).
To turn on the system power that you
turned off, wait at least 30 seconds
before power-on.
Before executing the operations,
explained in "Explanation", please
execute any of the following
procedures.
• Perform maintenance to fix the
malfunctions and configuration
violations.
• Stop all domains.
[How to restore]
Perform maintenance to fix the
malfunctions and configuration
violations. Restart the domain after
that.
Update the XCP firmware to XCP 1118
or newer.
Update the XCP firmware to XCP 1118
or newer.