Fujitsu SPARC Enterprise M3000 Product Notes page 66

XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O
111227-001
RTIF1- O
120216-001
RTIF1- O O
120319-001
RTIF1- O O
120322-001
RTIF1- O O
120326-001
RTIF1- O O
120329-004
RTIF1-
120424-001
50 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
M8000
M9000 Description
O In case of connecting an External I/O
Expansion Unit, a message
"watchdog timeout" might be
registered in an error log under the
following conditions:
• Executes the switchscf(8)
command on an M8000/M9000
server.
• Executes the rebootxscf(8)
command on an M4000/M5000
server.
O Using PCI hot-plug, when you
perform active addition of a PCI card
or perform active maintenance or
active addition of an external I/O
expansion unit, operation may fail.
O An internal module of the fmd
process (case-close module) turns
disable.
If you continue the operation in a
situation that the case-close module is
disabled, an fmd process failure
occurs and resets XSCF.
O While starting the XSCF, SSH service
might be disabled and cannot perform
SSH connection.
O Executing the setldap -p command
with a password that contains a colon
(:) causes a problem with the LDAP
configuration.
O When the XSCF unit is monitored by
Ops Center, the service processor can
sometimes reset or failover
unexpectedly.
O There is a low probability that FRU
replacement, which is performed by
the replacefru(8) command, fails
during the replacement of XSCF
boards in reaction to an XSCF board
failure.
Workaround
No workaround is available.
Stop the target domain before the
addition of a PCI card or before the
maintenance or addition of an
external I/O expansion unit.
No workaround is available.
Wait for the XSCF finish starting, and
then retry SSH connection. If SSH
service has been disabled, reset the
XSCF using the rebootxscf(8)
command.
No workaround is available.
To recover, execute
restoreconfig(8) to restore the last
working LDAP configuration.
Disable Ops Center monitoring of the
XSCF unit.
No workaround is available.