A-B Repeat; Programmed Playback - Teac CD-RW890MKII Owner's Manual

A-B Repeat

You can play back the designate point of track repeatedly .
Start playback and designate the point at which the A-B repeat
should start (point A) by pressing the A-B button .
"REPEAT A-" blinks on the display .
When the point at which repeat playback should end (point B) is
reached, press the A-B button again .
The designated section will be played repeatedly .
< The interval between points A and B must be 10 seconds or longer .
< CD-R/CD-RW discs that have not been finalized cannot be used for
A-B repeat .
< After designating point A, the Search (m/,) button can be
used to fast-forward or fast-backward to point B .
Note that the point B should be forward the point A . Do not go
back beyond the point A .
< The Skip (.//) buttons do not work during A-B repeat .
< A-B repeat does not work during programmed playback and
shuffle playback .
< Shuffle playback does not work during A-B repeat .
< If one of the following buttons is pressed, A-B repeat will be
canceled:
A-B, Stop (H), OPEN/CLOSE (L), POWER
14

Programmed Playback (1)

Up to 32 tracks can be programmed in the desired order .
< Insert a disc before beginning programming .
< Programmed playback works with finalized discs only .
1
Press the PROGRAM button in the stop mode.
"PROGRAM" indicator blinks, and "0P00" appears on the display .
2
Press the numeric button to select a track.
track 7:
track 10:
The selected track is programmed . To program more than one
track, press the numbers subsequently .
track number program number
You can also use the Skip (.//) button and the PROGRAM
button to program tracks . Select a track using the Skip (.//)
button, and press the PROGRAM button . Repeat this step to
program other tracks .
< If you made a mistake, press the CLEAR button . The last
programmed number will be deleted .
< To stop programming, press the Stop (H) button . The program
indicator (PROGRAM) stops blinking and lights up . When the
PROGRAM button is pressed again, the "PROGRAM" indicator starts
blinking again, and you can continue programming .
total time of the programmed tracks