Remote Control; Installing The Batteries For The Remote Control; Operating With The Remote Control - Sanyo FWSB426F Owner's Manual

Remote Control

Installing the Batteries for the Remote Control

Install 2 AAA (1.5V) batteries matching the polarity indicated inside battery compartment of the Remote Control.
1 2
NOTE(S)
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, Li-ion, etc) batteries.
• Do not mix old and new batteries.
• Always remove batteries from the Remote Control if they are dead or if the Remote Control is not to be used for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.

Operating with the Remote Control

1
2
3
4
5
6
7
8
9
Buttons
(POWER/Standby) Press to Turn On the
Unit, or to switch the Unit into Standby mode.
1
( To completely Turn Off the Unit, you must
unplug the AC Power cord.)
Press to switch to the Standard preset sound.
2
Press to switch to the preset sound for Sports
3
scene.
Press to switch to the preset sound for Music.
4
Press to Mute the Sound and press again to
5
Unmute the Sound.
Press to select Optical or Coaxial Input of the
connected device to this Soundbar.
If this button is pressed while Optical or
6
Coaxial is selected, the Current Input Source
will be switched back and forth between the
two Sources.
EN
• The maximum operable ranges from the Unit are as follows.
3
– Line of sight:
– Either side of the center: approx. 16 feet (5m) within 30°
– Above:
– Below:
10
11
12
13
14
15
16
17
18
19
Description
approx. 23 feet (7m)
approx. 16 feet (5m) within 15°
approx. 10 feet (3m) within 30°
Buttons
Press to select Line Input of a connected
7
device to this Soundbar.
Press to select USB Input of a connected
8
device to this Soundbar.
Press to select Auxiliary Input of a connected
9
device to this Soundbar.
Press to adjust Volume Up / Down on the
10
Soundbar.
Press to switch to the preset sound for a
11
Movie.
Press to switch to the preset sound for News
12
scene.
Press to turn Night Mode On/Off.
13
Press to turn Surround On/Off.
14
Press to select Bluetooth signal of a connected
15
device to this Soundbar.
Press to disconnect the currently connected
Bluetooth compatible Device and start pairing
mode to establish a new connection to another
Bluetooth compatible Device.
16
If no Bluetooth compatible Device is
connected within 2 minutes, press this button
to restart pairing mode. Pairing mode can only
be started when Bluetooth is selected.
Press to Skip Forwards in a music file.
17
(Bluetooth Mode and USB Mode only)
Press to Play or Pause a music file.
18
(Bluetooth Mode and USB Mode only)
Press to Skip Backwards in a music file.
19
(Bluetooth Mode and USB Mode only)
– 8 –
Description