Auto Standby Function; Installing The Soundbar On A Wall - Sanyo FWSB426F Owner's Manual

Auto Standby Function

• This Soundbar will automatically go into Standby mode for Energy Saving if no Audio Signal has been input for more than 20
minutes.
• In order to use the Soundbar again while it is in Standby mode, press

Installing the Soundbar on a Wall

1
Purchase the screws (x 2) by length/diameter below, now make screw holes on the vertical
interior Wall.
2
Hang the Soundbar over the screws.
• There is a Wall Mounting Template on page 21 or in the Setup Manual.
NOTE(S)
Funai is not liable for these types of accidents or injury noted below.
• Do not mount the Soundbar onto the Wall while your Soundbar is plugged in or Turned On. It may result in an
electrical shock injury.
• Install the screws on a sturdy vertical Wall. If installed onto a Ceiling or slanted Wall, the Soundbar may fall which
could result in a severe injury.
• Make sure that the Wall where you are mounting the Soundbar is appropriate. Some mounts are not designed to be
mounted to Walls with steel studs or cinder block construction. If you are unsure, contact a professional installer.
• Do not fasten the screws using excessive force. This may damage the product or cause the product to fall, leading to
an injury.
• Never allow children to climb on or play on the Soundbar.
EN
9/64"~5/32"/3.5~4mm
5/32"/4mm
>1-3/16"/30mm
on the Remote Control.
(OPTIONAL)
Molly Anchor
– 19 –