Maintenance Of The Print Head And Platen Roller; Maintenance Using The Cleaning Kit - SATO CL4NX Operator's Manual

5 Cleaning and Performing Printer Adjustments
5.2 Maintenance of the Print Head and Platen
Roller
Maintenance should be performed at the following regular intervals:
• After you print one media roll or print media for one hundred and fifty meters.
Use the cleaning kit to clean these parts:
• Print head
• Media sensors
• After you print six media rolls or print media for nine hundred meters.
Use the cleaning sheet to clean these parts:
• Print head
Use the cleaning kit to clean these parts:
• Media route
Maintenance intervals for the optional linerless kit (CL4NX only):
• After you print one media roll or whenever there is any glue residue or paper dust on the media route.
Use the cleaning kit to clean these parts:
• Print head
• Media sensors
* There is no need of cleaning the linerless platen roller unless it is significantly soiled.
Note
The above maintenance intervals are only for reference. Perform the cleaning when necessary.
5.2.1

Maintenance using the Cleaning Kit

The maintenance procedure using the cleaning kit is as follows:
CAUTION
Never use organic solvents, such as thinner and benzine to clean the printer.
Note
For details on the cleaning kit, refer to the manual attached to the cleaning kit.
1
Make sure that the printer is in power off mode, then disconnect the power cord from
the AC outlet.
238
CL4NX/CL6NX Operator Manual
• Platen roller
• Media guide
• Platen roller
• Ribbon route
• Media guide
• Guide rollers