Elite SL-3000-UL SERIES Instruction Manual page 17

QCC
W4
A B
G B A
MS LINK
OPEN STOP CLOSE M A G L O C K A L A R M A R M E D M/S LINK
QCC is designed for slide gate operators only!
1 2 – Open Command
&
3 4 – Stop Command
&
5 6 – Close Command
&
7 – Common
8 – Normally Closed
9 – Normally Open
Q C C
QCC Access ID (Top Positive)
QCC Access ID
Elite Part #
O-QCC OMNI
the QCC can operate in two different modes. The mode of operation will depend on the switch on the Omni option
board.
Mode A (switch off) If the gate is closing while a car is driving over the safety loop detector, the QCC will stop the
gate for a second then open the gate while the car is over the safety loop detector. As soon as the car leaves the
safety loop, the QCC will resume closing the gate.
Mode B (switch on) If the gate is closing, and a vehicle drives over the safety loop, the QCC will stop the gate. It
will not open the gate. After the vehicle leaves the safety loop, the QCC will close the gate.
SYSTEM ON TIMER
SENSORS
60 3
1 3
OFF ON
1 3 1 3
OPEN LEFT OPEN RIGHT
FIRE STRIKE RADIO GATE
DEPT. OPEN RECEIVER LOCKED
1
EXIT SAFETY CENTER RESET
LOOP LOOP LOOP MOTOR
Maglock or
Solenoid
( Q U I C K C L O S E
QCC Access Socket
Omni Option Board
Elite Part #
QCC socket with QCC access ID inserted
QCC "Mode of Operation" switch
QCC
A B
DC-BACKUP
OPEN STOP CLOSE MAGLOCK
POWER
OVERLOAD
2 3 4 5 6 7 8 9 10 11 12 13 14 15
10 11 – Burglar Alarm Output
&
12 13 – Burglar Alarm Input
&
14 – Ground
15 – B
16 – A
C U R C U I T )
O-OMNI EXB
A L A R M M/S LINK
ARMED
16
Omni Option Board
Elite Part # O-OMNI EXB
Master/Slave
RS485
Mode of Operation Switch