Installing The Scanner Drivers; Using Windows98/Me, Windows2000; Installing The Sti Driver - Ricoh IS330DC Setup Manual

Hide thumbs Also See for IS330DC:

Table of Contents

2. Installing the Scanner

This chapter assumes that the reader has sufficient understanding of the Win-

dows operating system. Refer to the Windows operation manual for details

about its functions and operation.

The ways for installing the scanner driver on your computer vary depending on

your operating system. Follow the procedures described below (The following

is an explanation on how the TWAIN driver is installed. When installing the ISIS

Driver, refer to P.16 "Installing the Scanner Driver by Auto Run" and proceed with

the installation as mentioned there.).

Note

The scanner driver in this manual is TWAIN or ISIS driver.

Install the Scanner driver after having installed the STI driver for Windows98/

Me or Windows2000 using the Plug & Play function of the OS. Here examples of

Windows98 are used for the explanations. The basic operations are similar for

Windows Me and Windows2000.

When connecting the scanner to a PC and the PC is started, the scanner can pos-

sibly be recognized as a different device. In order to allow the scanner to be rec-

ognized properly, it is necessary to install the STI driver stored on the supplied

CD-ROM. When using this product with Windows98/Me or Windows2000 be

sure to always install the STI driver.

Limitation

To install the driver when using Windows2000, log-on as an Administrator

group member.

Note

During the installation of the STI driver, the Windows98/Me or

Windows2000 CD-ROM may be required.

Connect the scanner and start up the PC.

When starting up the PC for the first time after connecting the scanner, the

[Add New Hardware Wizard] appears.

drivers

7,19

Table of Contents