Connecting To The Host; To Connect To Your Host - Ricoh IS450DE Operator's Manual

Use the following procedure to connect the scanner to a host computer using a
SCSI cable.
Note the following important points when making SCSI cable connections.
Turn all devices being connected before making any connections.
The use of cables other than the specified shielded cables or their
equivalents will invalidate your scanner's certification and can cause
interference levels that exceed the limits established for this equipment.
The total length of the SCSI bus should not exceed six meters.
Either of the scanner's two SCSI connectors can be used for the connection,
but any unused SCSI connector must be capped with a terminator.
Note:The RS-232C connector is employed only when the optional
Operation Panel is being used.

To connect to your host

1
Make sure that the scanner and
all the other devices in the SCSI
chain are turned off.

CONNECTING TO THE HOST

SETTING UP THE SCANNER
1-5