Cab-1 Commands For Your Locomotive - Lionel Building Set Owner's Manual

TrainMaster Command operations
Running your locomotive in the TrainMaster
Command environment
Address Locomotive #1
Example
PowerMasters set to CMD or traditional
power supplies ON FULL
Press ENG
Press 1 (the ID#)
Throttle up/press any command button

CAB-1 commands for your locomotive

Locomotive
RailSounds effects
in bold italic.
Coupler release
sounds.
Tender rear coupler
releases.
Coupler release sounds.
Press AUX2 to turn
your locomotive's
headlight on and off.
Turn the THROTTLE
to the right to accel-
erate, left to deceler-
ate. Speed-depen-
dent variable steam
chuffing. DynaChuff
dynamic chuffing effect.
PressHALT to shut down all
PowerMaster electrical
output on your railroad.
Stops all Command-equipped Lionels
in operation.
NOTE: Use "HALT" only in "emer-
gency" situations.
Y our Command-equipped loco-
motive comes factory-pro-
grammed with an ID# of "1." To get
your locomotive into action, set
PowerMasters to CMD or set all power
supplies on full. Press ENG and "1"
on CAB-1. Turn the throttle or press
any command button; RailSounds
starts up. Your locomotive is ready
for Command operations.
discontinue. Multi-Whistle steam
whistle sound.
Traditional bell sound.
throttle up, and the locomotive
moves in the opposite direction.
There is no neutral. Steam air-
release sound.
locomotive's previous speed.
Labored chuff.
return to the previous speed.
Squealing brake sounds.
11
Press WSTL/HRN to
activate the locomotive's
whistle, release to
Press BELL once to
activate the bell, again
to discontinue.
Press DIR—the loco-
motive decelerates to a
complete stop; turn the
Press and hold BOOST
for extra power. Release
BOOST and return to the
Press and hold BRAKE to
slow down or stop.
Release BRAKE and