Example: adjust the level of Analog Outs 1&2, which are connected to your powered
monitors.
1. Touch "Out" on the bottom row.
- The LED turns green (Signal Level mode); you may want to touch it again to toggle it
to Gain Set mode.
2. Touch "1" and "2" on the top row (or either one if they're configured as a stereo pair).
3. Turn the Rotary Knob to adjust the level.
Rotary Knob Push functions
FUNCTION
Mute all outputs
Save all settings to internal memory
Power down
Power up
Bootloader mode (for manual firmware updates)
Reset
LED Meter Levels
48V
Inst
ROTARY KNOB PUSH COMMAND
Double push
Single push
Push and hold until each meter shows a single red
and a single amber LED
Single push (when powered down)
Push and hold until each meter shows a single red
LED, then release
Push and hold until all LEDs turn off, then release
19