Using The Touch Panel And Main Rotary Encoder - iConnectivity PlayAUDIO 1U User Manual

Using the Touch Panel and Main Rotary Encoder

The rotary encoder is continuous and can make fine or coarse adjustments depending on how quickly you rotate the dial. Fine adjustments are
recommended if there is a risk of signal overload. Rotary Encoder Press functions include:
Committing Settings to Memory Short press the Main Rotary Encoder twice to save settings. A notification will appear on the OLED and all
Restart unit
Enter Bootloader Mode
View Interface Information
Pressing any of the PlayAUDIO1U touch zones toggles the zone to the next available state. Currently either touch zone above or below a respective
label has an identical effect.
Scene: Each single touch of either cap touch buttons above or below the Scene label toggles the current scene between A and B. The current
scene selection is indicated by a large letter A or B on the OLED display, or the following::
Scene A: Green cap touch button above the Scene label
User Guide v2023-001
cap-touch buttons will flash amber twice
Long press for approximately 8 seconds until all cap-touch buttons have turned off after illuminating in amber,
then release.
Shutdown using the rear power switch. Long press the multifunction encoder until all cap-touch buttons
illuminate in amber and release.
From the Home page, short press once to display your interface's Serial Number, Firmware version,
Hardware version, and MAC Address
Scene B:Red cap touch button below the Scene label
14