iConnectivity iConnectAUDIO 2 Owner's Manual page 28

Other info about the mixer:
- Double-click most faders and the BAL (Balance) knobs to set them to 0.
- The rest of the controls are as follows:
The USB Mixers
There are two USB mixers, one for each computer device. These are for mixing analog
and/or computer input channels to send to a computer output channel. Each USB mixer
can accept inputs from either computer/iPad or any analog input, but it can only be
routed to one computing device.
To enable one or both USB mixers, go to the Audio Information tab. In this example
we've set up four channels on computer #1 (AKA "iCA2 USB D1 domain" in the
software). We're not using the other USB mixer, since it's not needed.
After clicking Commit and Reset, the iConnectAUDIO2+ restarts. The Patchbay is
cleared and you will need to define the routing for your new configuration.
28