Rear Panel - iConnectivity iConnectAUDIO 2 Owner's Manual

Rear Panel

5 Power jack for the optional iConnectivity Power Transformer (sold separately)
Please use only the iConnectivity 9V center positive transformer, or you risk damaging
the device.
The iConnectivity Power Transformer operates over a range of 100-240V/50 or 60Hz,
so it can be used internationally with wall plug adapters.
6 Computer Device jack 2
Connect the interface to a Mac or PC with the included iConnectivity USB-B to USB-A
cable. Or connect an iPad using the Apple Lightning cable that came with your iPad.
The iPad will charge if you use the optional iConnectivity 9V Power Transformer.
7 Computer Device jack 1
Connect the interface to a Mac or PC with the included iConnectivity USB-B to USB-A
cable.
Only this jack will power the device over the USB bus, so please use it if you're only
connecting one Mac or PC.
8 MIDI DIN In & Out
These jacks accept 5-pin MIDI DIN plugs for standard MIDI hardware. MIDI is
transmitted at the standard MIDI rate (31.25 Kbps).
Analog Out Jacks 1 – 4
9
¼" balanced TRS outputs. The output is 13dBu/11dBV, a very high level, so please use
caution to avoid overloading subsequent equipment in the signal path.
Normally Analog Outs 1 & 2 would be connected to powered monitors or a stereo amp +
speakers.
– Headphone Jack
10
For stereo headphones with a ¼" TRS plug.
– Chassis grounding screw
11
In case of grounding issues when connecting multiple electronic devices.
16