Philips LC7.1E Service Manual page 14

EN 14 4. LC7.1E LA
4.3.8 Main Supply Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Main supply panel" below.
3. Unplug cables [a].
4. Remove the fixation screws [b].
5. Take the board out (it hinges at the left side).
a
Figure 4-14 Main supply panel
f (1x)
g (2x)
g (2x)
f (3x)
Mechanical Instructions
b (3x)
a
a
G_16860_065.eps
010207
a
f (2x)
d
Figure 4-15 LCD panel [1/2]
4.3.9 LCD Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. "LCD panel" below.
3. Unplug the connectors on the Main Supply Panel [a] and
the LED & IR board [c].
4. Unplug the outer connectors [d] from the mid-range
loudspeakers.
5. Do NOT forget to unplug the LVDS connector [e] from the
SSB. Important: Be careful, as this is a very fragile
connector!
6. Remove T10 parker screw [b] that holds the Side I/O
module bracket.
7. Remove T10 parker screws [f] of the central sub-frame.
8. Remove LCD panel fixation screws [g] and lift the complete
central sub-frame from the set (incl. the PSU, SSB, and
Side I/O boards and wiring).
9. Lift the LCD panel [7] from the front cabinet.
e
b
d
c (1x)
G_16860_067.eps
310107