Philips LC7.1E Service Manual page 13

2 g
Figure 4-9 Side I/O panel [3/3]
4.3.4 IR/LED Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. "IR/LED panel" below.
3. Unplug connector(s) [1].
4. Release clip [2] and remove the board.
When defective, replace the whole unit.
1
Figure 4-10 IR/LED panel
f
G_16860_077.eps
010207
2
G_16850_009.eps
110107
Mechanical Instructions
4.3.5 Mid-range Speakers
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Mid-range speakers" below.
3. Unplug connectors [1].
4. Remove T10 parker screws [2].
4.3.6 Tweeters
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Tweeters" below.
3. Unplug connectors [1].
4. Remove T10 parker screws [2].
2
4.3.7 Small Signal Board (SSB)
1. Remove the rear cover, as described earlier.
2. Refer to fig. "SSB removal" below.
3. Disconnect all cables [a] on the SSB.
4. Remove the T10 tapping screws [b] that hold the SSB. See
Figure "SSB removal".
5. Remove the screws that hold the CINCH and HDMI
connectors at the connector panel.
6. Lift the SSB from the set.
LC7.1E LA
2 1
Figure 4-11 Mid-range speakers
1
Figure 4-12 Tweeters
a a
b (3x) b (2x)
b (2x)
Figure 4-13 SSB removal
4. EN 13
2
G_16850_010.eps
110107
G_16850_011.eps
110107
b (3x)
G_16860_074.eps
010207