Black & Decker GL710 Original Instructions Manual page 6

ENGLISH
Never touch the cutting line while the appliance is running.
u
Do not put the appliance down until the cutting line has
u
come to a complete standstill.
Use only the appropriate type of cutting line.
u
Never use metal cutting line or fishing line.
Be careful not to touch the line trimming blade.
u
Take care to keep the mains cable away from the cutting
u
line. Always be aware of the position of the cable.
Keep hands and feet away from the cutting line at all
u
times, especially when switching on the motor.
Before using the appliance and after any impact, check for
u
signs of wear or damage and repair as necessary.
Never operate the appliance with damaged guards or
u
without guards in place.
Take care against injury from any device fitted for trimming
u
the filament line length. After extending new cutter line
always return the machine to its normal operating position
before switching on.
Always ensure that the ventilation slots are kept clear of
u
debris.
Do not use the lawn trimmer (edge trimmer), if the cords
u
are damaged or worn.
Keep extension cords away from cutting elements.
u
Labels on appliance
+
The following warning symbols are found on the appliance:
F Read the manual prior to operation.
Wear safety glasses or goggles when operating this
8 appliance.
Keep people and animals at least 6 m away from the
R cutting area.
Do not expose the appliance to rain or high humidity.
Electrical safety
#
This appliance is double insulated; therefore no earth
wire is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Handle
6
3. Cable restraint
4. Power inlet
5. Secondary handle
6. Adjustment button
7. Tube
8. Guard
9. Line trimming blade
10. Spool housing
11. Cutting line
12. Edge guide
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Fitting the guard (fig. A)
Remove the hexagonal screws (13) from the head (14).
u
Place the guard (8) onto the appliance as shown.
u
Firmly press the guard until it snaps into place.
u
Secure the guard with the hexagonal screws.
u
Tighten the hexagonal screws using the hexagonal key
u
(15) provided.
Warning! Never use the appliance unless the guard is
properly fitted.
Releasing the cutting line
In transit, the cutting line is taped to the spool housing.
Remove the tape holding the cutting line (11) to the spool
u
housing (10).
Connecting the appliance to the mains
Connect the female plug of a suitable extension cable to
u
the power inlet (4).
Loop the cable through the cable restraint (3).
u
Insert the mains plug into a mains outlet.
u
Warning! The extension cable must be suitable for outdoor use.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any rotating/moving
u
parts.
Injuries caused when changing any parts, blades or
u
accessories.
Injuries caused by prolonged use of a tool. When
u
using any tool for prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u