Getting Started - Waterpik Ultra Dental Water Jet Manual



GETTING STARTED

Plug the cord into an electrical outlet. If the outlet is
controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Remove reservoir and cover from base. Fill
the reservoir with lukewarm water. Replace the
reservoir over the base and press down firmly.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of
the dental water jet handle. The colored ring will be
flush with the end of the knob if the tip is correctly
locked into place. To remove tip from the handle,
press the tip eject button and pull tip from handle.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the
unit to the lowest setting (pressure setting No. 1)
for first-time use. Gradually increase pressure over
time to the setting you prefer – or as instructed by
your dental professional.
Placement in Mouth
Lean low over sink and place the jet tip in mouth.
Aim the tip toward teeth.
With your free hand, turn
the unit on. Set pressure
at desired setting.
Direct the stream by
turning the knob at
the top of the handle.