Do you have a question about the Complete Care CC-01 and is the answer not in the manual?
Questions and answers
Claudia Hance
January 17, 2025
I have a CC-02w/CC-02C Waterpik combo. The toothbrush no longer works. The Flosser does. Is there a fix for that?
1 comments:
Mr. Anderson
May 14, 2025
If the toothbrush in the Waterpik CC-02 combo is not working but the flosser still works, check the following:
- Ensure the product is properly charged. - Do not use if the cord or plug is damaged. - Do not use if the product is not working properly, has been dropped or damaged, or dropped into liquid.
If the toothbrush still does not work, and the product has not been opened or disassembled (which voids the warranty), contact Waterpik service for assistance. There are no user-serviceable electrical components in the unit.
IMPORTANT SAFEGUARDS IMPORTANT WARNING: SAFEGUARDS To reduce the risk of burns, electrocution, fire, or injury to When using electrical products, especially when persons: children are present, basic safety precautions should always be followed, including the following: • If product is opened/disassembled for ANY reason warranty is VOID.
Page 3
• Keep electrical cord away from heated surfaces. • Using toothpastes containing peroxide may damage the plastic housing of this product. • Do not use Water Flosser or Toothbrush outdoors or operate where aerosol (spray) products are • Using abrasive or chemical cleaners may damage being used or where oxygen is being administered.
Page 5
TABLE OF CONTENTS Product Description Getting Started With Your Water Flosser Cleaning and Troubleshooting Your Waterpik Water Flosser ® Getting Started With Your Sonic Toothbrush Getting Started With Your Oscillating Toothbrush Care of Your Waterpik ® Toothbrush Disposal and Battery Removal...
PRODUCT DESCRIPTION Water Flosser 1. Hinged Reservoir Lid 2. Reservoir 3. Hose 4. Water Flosser Pressure Control Dial 5. Power Button (Push to turn unit on/off) 6. Power Cord 7. Magnetic Handle Cradle 8. Tip 9. Tip Eject Switch 10. Water On/Off Switch 11.
W h it e n M a s s a g e Replacement tips/attachments may be purchased directly from Waterpik International, Inc. +44 (0) 333 123 5677 or from your local Water Pik stockist. C H A R G E...
GETTING STARTED WITH YOUR WATER FLOSSER Powering the Unit Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be sure it is turned on. Fill Preparing the Reservoir Lift the reservoir lid, remove the reservoir, and fill with lukewarm water. Replace the reservoir over the base and press down firmly and close the lid.
Page 9
When Finished Turn the unit OFF. Empty any liquid left in the reservoir. Unplug the unit. NOTE: If you used mouthwash or other solution besides water, see “Using Mouthwash and Other Solutions” section. NOTE: NOT ALL TIPS INCLUDED WITH ALL MODELS. TIP USAGE Plaque Seeker®...
This process should be done every 1 to 3 months to ensure optimal performance. Leakage If leaking due to a damaged hose, replacement hoses and handles can be purchased at waterpik.co.uk or contact Water Pik Inc. customer service for a self service repair kit.
Page 11
GETTING STARTED WITH YOUR SONIC TOOTHBRUSH Charging the Sonic Toothbrush Charge for 24 hours before first use. All 3 charge indicator lights will stay on continuously when the unit is fully charged. A full charge will last for approximately 1 week of typical use (2 minutes of brushing twice a day). If the toothbrush is to be stored for an extended period of time (six months or more), be sure to fully charge it prior to storage.
Page 12
GETTING STARTED WITH YOUR OSCILLATING TOOTHBRUSH Charging the Oscillating Toothbrush Charge for 24 hours before first use. When the toothbrush is fully charged, the charge indicator will be green while sitting on the base. A full charge will last for approximately 1 week of typical use (2 minutes of brushing twice a day). If the toothbrush is to be stored for an extended period of time (six months or more), be sure to fully charge it prior to storage.
CARE OF YOUR WATERPIK TOOTHBRUSH / ® DISPOSAL AND BATTERY REMOVAL Cleaning 1. After each use, turn off unit, remove the brush head from the handle and rinse brush head under running water. 2. Wipe the handle dry after each use.
Water Flosser are also available at www.waterpik.co.uk. For questions or problems please call the customer service centre before returning the product. Please do not send your unit to the Waterpik International, Inc. address as this can cause lengthy delays. Refer to the serial and model numbers in all correspondence.
Page 15
Water Pik, Inc. Waterpik, International, Inc. Waterpik, International, Inc. 1730 East Prospect Road Castle Court, 41 London Road UK Customer Service Centre Fort Collins, CO 80553-0001 USA Reigate, Surrey RH2 9RJ +44 (0) 333 123 5677 844-821-4873 United Kingdom www.waterpik.com www.waterpik.co.uk...
Need help?
Do you have a question about the Complete Care CC-01 and is the answer not in the manual?
Questions and answers
I have a CC-02w/CC-02C Waterpik combo. The toothbrush no longer works. The Flosser does. Is there a fix for that?
If the toothbrush in the Waterpik CC-02 combo is not working but the flosser still works, check the following:
- Ensure the product is properly charged.
- Do not use if the cord or plug is damaged.
- Do not use if the product is not working properly, has been dropped or damaged, or dropped into liquid.
If the toothbrush still does not work, and the product has not been opened or disassembled (which voids the warranty), contact Waterpik service for assistance. There are no user-serviceable electrical components in the unit.
This answer is automatically generated