Getting Started With Your Water Flosser - Waterpik WP-940 Instruction Manual

6

GETTING STARTED WITH YOUR WATER FLOSSER

Replace Every 3 Months
Orthodontic Tip
Pik Pocket™ Tip
Plaque Seeker Tip
®
Sensonic ®
Standard Brush Head
Sensonic
®
Compact Brush Head
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is
controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill
with lukewarm water. Replace the reservoir over the
base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser
handle, pressing down firmly until the tip clicks into
place. The colored ring will be flush with the top of
the handle if the tip is correctly locked into place.
To remove tip from the handle push the tip eject
button on the handle.
BEST FOR
Braces
General Use
BEST FOR
Periodontal Pockets
Furcations
BEST FOR
Implants Retainers
Crowns General Use
Bridges
BEST FOR
Plaque Removal
BEST FOR
Plaque Removal
Replace Every 6 Months
Classic Jet Tip
Tongue Cleaner
NOTE: All tips and brush heads not included
in all models.
Replacement tips/attachments may be purchased
online at www.waterpik.com, or by phone from
Water Pik, Inc. at 1-800-525-2774. To find
detailed information about tips, other accessories,
and product usage please visit our website at
www.waterpik.com.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure
setting No.10), point the handle and tip into sink.
Turn power and water ON until water flows from the
tip. Turn unit OFF.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the
unit to the lowest setting (pressure setting No.1) for
first-time use. Gradually increase pressure over time
to the setting you prefer – or as instructed by your
dental professional.
BEST FOR
General Use
BEST FOR
Fresher Breath