Care Of Glass; Cleaning The Heat Exchanger Tubes; Make Sure Pellets Are Not Piling Up - Napoleon NPS45 Installation And Operating Instructions Manual

38
10.1.5

CARE OF GLASS

If the glass is not kept clean permanent discolouration and / or
EN
blemishes may result. Normal operation of your pellet appliance
will produce a build-up on the glass that should be wiped off
daily. However, poor quality pellets or extended burning on the
low setting will cause the glass to "smoke up" faster.
Refer to "REPLACEMENT PARTS" section to fi nd out what this
product is equipped with. Use only replacement glass available
from your Authorized dealer.
DO NOT CLEAN GLASS WHEN HOT!
If necessary, clean the glass with a soft cloth or paper towel. You could use "wood stove" glass cleaner to
remove heavy build-up.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
10.1.6

CLEANING THE HEAT EXCHANGER TUBES

THE FRONT EDGE OF THE HOPPER LID BECOMES VERY HOT, DO NOT TOUCH THE AREA BELOW
THIS ROD BECOMES VERY HOT DURING OPERATION. WAIT UNTIL APPLIANCE HAS COOLED
COMPLETELY OR WEAR HEAT RESISTANT GLOVES WHEN CLEANING OR HANDLING THIS
With the appliance cool (or wearing heat resistant gloves),
slide the heat exchange cleaner rod up and down several
times to prevent the build up of ash on the heat exchange
tubes.
Keep the viewing door closed so the fl y ash does not enter the
room.
NOTE: More frequent cleaning may be required depending
upon pellet quality.
10.1.7

MAKE SURE PELLETS ARE NOT PILING UP

If the fl ames seem to be coming only from the sides, are orange/black, turn
the appliance off and check for a build up of pellets. If the pellets build up over
the burn pot, turn the pellet feed switch to "OFF".
The most likely causes are:
A. Feed rate has been set to maximum for an extended period of time.
Reduce feed rate.
B. The door, glass, or ash pan is open or has an air leak.
C. The burn pot requires cleaning.
D. The exhaust system requires cleaning.
E. The appliance requires adjustment (trim feed rate and blower).
F. Poor pellet quality.
E. Ensure the leveling bolts are installed in the front corners of the
fi rebox base (TP35 series only).
W415-1472 / 04.21.15
WARNING
!
THE HANDLE.
APPLIANCE.
HEAT
EXCHANGE
CLEANER
ROD
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
5.2
40.4A