2.2 Installation of the Hybrid IP-PBX
2.2.9
Wall Mounting (KX-TDA15)
Mounting on Wooden Wall
1.
Place the reference for wall mounting (on the last page of this manual) on the wall to mark the 3 screw
positions.
2.
Install the screws and washers (included) in the wall.
Washer
Drive the screw
to this position.
Notes
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Hook the main unit on the screw heads.
Notes
•
Do not block the openings of the cabinet. Leave at least 20 cm of space above and 10 cm to the
sides of the Hybrid IP-PBX for ventilation.
•
Make sure that the surface behind the cabinet is flat and free of obstacles, so that the openings on
the back of the cabinet will not be blocked.
•
Be careful not to drop the cabinet.
50
Installation Manual
130 mm
250 mm