Download  Print this page

Operation - Panasonic KX-TDA15 Installation Manual

Hybrid ip-pbx.
Hide thumbs

Advertisement

4.1.3

Operation

PROBLEM
When using the
speakerphone on an APT,
nothing is audible.
When using the
speakerphone/monitor
mode with a DPT, nothing is
audible.
The PT does not ring.
Originating an outside call,
call transfer, or conference
cannot be performed.
Cannot register the PS.
PS becomes out of range.
Cannot make calls using the
PS.
Noise is frequent while using
the PS.
Conversations disconnect
while using the PS.
PS stays out of service
when the CS status is
changed from Out of
Service to In Service.
PROBABLE CAUSE
The HANDSET/HEADSET
selector is set to the
"HEADSET" position.
The "HEADSET" mode is
selected by Personal
Programming, "Handset/
Headset Selection".
The ringer volume is off.
The corresponding CO
button does not exist on the
PT.
Wrong Personal
Identification Number (PIN)
is registered to the PS.
CS is not connected
properly.
CS is not working.
Location of CS is not good. •
Access system of the PS is
not properly set.
Call handover is not
working.
PS is out of CS coverage
area.
It may take about 10 s for
CS to start up after the
status has been changed to
In Service.
SOLUTION
When the headset is not used, set the
HANDSET/HEADSET selector to the
"HANDSET" position.
When the headset is not used, select
the "HANDSET" mode by Personal
Programming.
Turn on the ringer volume.
Programme the CO button. Refer to
"1.18.2 Flexible Buttons" in the Feature
Guide.
Enter the PIN set to the Hybrid IP-PBX
into the PS.
Make sure that the cable is connected
properly with correct pin assignments.
Also, make sure that the cable does not
make short circuits.
Switch all DIP switches off.
Make sure that the cable is connected
properly with correct pin assignments.
Also, make sure that the cable does not
make short circuits.
Switch all DIP switches off.
Locate the CS properly (refer to "2.7.5
Site Survey Using the KX-TCA255/KX-
TD7590").
Change the access system setting of
the PS to the appropriate system or
automatic.
Locate the CS properly (refer to "2.7.5
Site Survey Using the KX-TCA255/KX-
TD7590").
Wait until the CS starts up.
4.1 Troubleshooting
Installation Manual
151

Advertisement

Table of Contents

   Also See for Panasonic KX-TDA15

   Related Manuals for Panasonic KX-TDA15

Comments to this Manuals

Symbols: 0
Latest comments: