Tuner Operation - Jensen JDVD1500 Installation And Operation Manual

TUNER OPERATION

Select a Band
Press the BAND button (6) on the control panel (or the SOURCE button on the remote control)
to change between three FM bands and two AM bands.
Manual Tuning
Turn the seek knob (17) to the left or right (or the TUNE+ or TUNE- button on the remote control)
to seek stations up/down step by step.
Auto Seek Tuning
Turn and hold the seek knob for more than 3 seconds (or press and hold the TUNE+ or TUNE-
button on the remote control) to automatically seek the next or previous strong station.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (8-13) for 3
seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (8-13) to select the corresponding stored
station.
Automatically Store / Preset Scan (AS/PS)
Automatically Store
Select a band (if needed). Press and hold the AS/PS button (14) for more than 3 seconds to
automatically select strongest stations (12 for AM, 18 for FM) and store them in the current band.
The new stations replace any stations already stored in that band.
Preset Scan
Select a band (if needed). Press AS/PS (14) to scan stations stored in the current band. The unit
will pause for 10 seconds at each preset station. Press AS/PS again to stop scanning when the
desired station is reached.
Stereo
The unit will automatically pick up a stereo signal, when available. When in stereo mode, the "ST"
icon appears in the display. When no stereo signal is available, the unit will automatically revert
to mono operation, and no icon will be displayed.
10
JDVD1500