Care and Cleaning
CAUTION
• Disconnect the power supply before cleaning and maintenance.
• Do not splash water on the units when cleaning, as electric shocks may occur.
• Wipe the units with a dry soft cloth, or a cloth slightly moistened with water or cleaner
(not with a volatile liquid such as paint thinner or gasoline).
Remove the front panel. Dip a piece of cloth into water that is below 45°C and wring it out. Then
wipe the dirty part of the front panel.
Note: Do not immerse the front panel in water to protect the microcomputer components and circuit
diagram on the front panel.
Note: Do not to touch the fin on the indoor unit when cleaning to avoid injury.
(1) Take down air filter
Lift up the front panel.
Pull the air filter downwards to take it off,
as shown in Fig.(a, b)
(2) Clean the air filter
Use a vacuum cleaner to remove dust.
If the filters are dirty, wash them with warm water
and a mild detergent.
Dry the filters in the shade.
Note: Never use water above 113°F to clean the
air filter as it can cause deformation or discoloration.
(3) Reinstall the air filter
Reinstall the filters along in the direction of the arrow.
Close the panel.
Cleaning the front panel
Cleaning the air filter (every 3 months)
14
(Fig.a)
(Fig.b)