Select Mode - Braun BP 3510 Manual

Repeatedly pressing the memory button (D) will call up
one by one all stored readings:
m (–) towards older readings
n (+) towards younger readings
Scrolling
Keep one side of the memory button pressed for
scrolling through the memory.
Press the on/off button (B) to exit the memory mode.

Select mode

Setting date and time
First turn off the appliance. Push the select button (C) for
longer than 3 seconds to enter the select mode. Wait for
a confirmation beep.
The day position of the displayed date starts flashing.
Using the memory button (D), you can adjust the date.
Press the select button again to make the month position
flash, adjust it using the memory button.
Press the select button again and proceed the same way
to adjust the time (hour/minute).
After having changed date and time, press the on/off
button (B) to confirm.
The device will then turn off.
Deactivating the position sensor
Should you wish to deactivate the position sensor (e.g.
because you want to measure while lying down), proceed
as follows:
Turn off the product. Push the select button (C) for longer
than 3 seconds and wait for the confirmation beep. The
display shows the date and time settings. Then repeat-
edly press the select button until the position sensor
symbol ( ) will be displayed next to a flashing «ON».
Press one side of the memory button to change the
setting from
«ON» (position sensor activated) to
«OFF» (position sensor deactivated).
To confirm the change of setting, press the on/off button
(B).
9