After Installing The Switch; Table- Or Shelf-Mounting - Cisco Catalyst 3650 Hardware Installation Manual

Installing the Switch

Table- or Shelf-Mounting

To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis (see
Figure 2-11
1
When you complete the switch installation, see the
for more information about the switch configuration.

After Installing the Switch

After the switch is installed, you might need to:
•
•
•
Catalyst 3650 Switch Hardware Installation Guide
2-14
Attaching the Adhesive Pads for Table- or Shelf-Mounting
1
Adhesive pads
Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
Use the CLI setup program to enter the initial switch configuration.
Connect to the front-panel ports. See the
page 2-19.
"After Installing the Switch" section on page 2-14
"Connecting Devices to the Ethernet Ports" section on
Chapter 2 Switch Installation
Figure 2-11).
1
OL-29734-01