Specification; Additional Safety Rules - Makita HR4040C Instruction Manual

ENGLISH
1 Bit grease
2 Bit shank
3 Bit shank
4 mark
5 Chuck cover
6 Bit
7 Cut in bit shank
8 Notch in tool holder cap
9 Lock button
10 Change lever
11 Pointer
12 Side handle

SPECIFICATION

Model
Capacities
Tungsten-carbide tipped bit ................................ 40 mm
Core bit ............................................................ 105 mm
–1
No load speed (min ) ..................................... 230 – 450
Blows per minute ....................................... 1,250 – 2,500
Overall length ..................................................... 470 mm
Net weight .............................................................. 6.6 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.
Explanation of general view
13 Can be swung 360° on the
vertical and secured at any
desired position
14 Secures at eight different
positions back and forth on the
horizontal
15 Clamp nut
16 Loosen
17 Tighten
18 Side grip
19 Switch trigger
20 Adjusting dial
21 Depth gauge
22 Clamp screw

ADDITIONAL SAFETY RULES

1.
HR4040C
2.
3.
4.
5.
6.
7.
8.
9.
10. When drilling or chipping into walls, floors or
11. Do not touch the bit or parts close to the bit
SAVE THESE INSTRUCTIONS.
23 Power-ON indicator lamp
(green)
24 Service indicator lamp (red)
25 Screwdriver
26 Brush holder cover
27 Brush holder cap
28 Screws
29 Connector
30 Black
31 White
32 Crank cap
33 Hex wrench
34 Hammer grease
Wear a hard hat (safety helmet), safety glasses
and/or face shield. It is also highly recom-
mended that you wear a dust mask, ear protec-
tors and thickly padded gloves.
Be sure the bit is secured in place before opera-
tion.
Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
In cold weather or when the tool has not been
used for a long time, let the tool warm up for sev-
eral minutes by operating it under no load. This
will loosen up the lubrication. Without proper
warm-up, hammering operation is difficult.
Always be sure you have a firm footing. Be sure
no one is bellow when using the tool in high
locations.
Hold the tool firmly with both hands.
Keep hands away from moving parts.
Do not leave the tool running. Operate the tool
only when hand-held.
Do not point the tool at any one in the area when
operating. The bit could fly out and injure some-
one seriously.
wherever "live" electrical wires may be encoun-
tered, DO NOT TOUCH ANY METAL PARTS OF
THE TOOL! Hold the tool by the insulated grasp-
ing surfaces to prevent electric shock if you drill
or chip into a "live" wire.
immediately after operation; they may be
extremely hot and could burn your skin.
7