Russell Hobbs 18995-56 Instruction Manual page 3

stop before removing the lid from the jug, and before removing the jug from the motor/
base unit.
This appliance is not intended for use by persons (including children) with
8.
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
9.
Do not use the blender without first locking the lid in place.
10.
Do not fill the jug with boiling liquids. Allow liquids to cool to a lukewarm temperature
11.
before you put them in the jug. This type of temperature would be comfortable to the
touch.
Do not put your hand into the jug, even when it has been removed for
12.
cleaning – the blades are very sharp.
Do not come into contact with moving parts.
13.
Do not put any other object (spoon, spatula, etc.) into the jug while the blender is
14.
plugged in.
Do not leave the blender unattended when plugged in.
15.
Misuse of this appliance can result in injury.
16.
Position the motor unit on a dry, firm, level surface, close to a power socket
17.
and out of reach of children.
Route the mains lead so that it cannot be caught accidentally or tripped over.
18.
Keep the blender and the mains lead away from hotplates, hobs and burners.
19.
Store the blender away from direct sunlight and fluorescent light where
20.
possible.
Do not let the jug overflow. If liquid gets under the motor unit, it may be
21.
sucked into the motor, damaging it.
Do not fill the jug above the MAX mark. If you do, the contents may force the
22.
lid off when you start the motor.
The blender is equipped with a powerful motor and therefore processes very
23.
quickly. Due to its efficiency there is no need to run the motor for more than 1
minute at a time.
Do not run the motor for more than 1 minute, either continuously, or using
24.
the pulse setting, otherwise it may overheat. After 1 minute of use, switch it
off for at least 2 minutes allowing it to cool to room temperature and allowing it
recover.