Section 4 − Installation; Selecting A Location - Miller hydracool 270 CE Owner's Manual

B. Information On Electromagnetic Fields (EMF)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974−1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner's Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.

4-1. Selecting a Location

.
Position unit so air can circulate.
OM-266 361 Page 6
SECTION 4 − INSTALLATION
500 mm
500 mm
500 mm
956172138_1-A
ce-emf 1 2010-10